Author Topic: Bed roughness in LitPack  (Read 2030 times)

TiNeu

  • Posts: 1
    • View Profile
Bed roughness in LitPack
« on: December 11, 2013, 05:05:48 pm »
Hello everyone,

I'm a bit struggling with the bed roughness in LitPack. I'm worrying about on which parameter the calculations are based. So I'm thinking about using Ks as it represents the bed roughness based on the grain size. However, colleagues of mine using Zo, But I'm not sure if Zo gets calculated by the simulation anyways.

Thanks for advises,
Tim

mdrodila

  • Posts: 2
    • View Profile
Re: Bed roughness in LitPack
« Reply #1 on: February 21, 2014, 04:39:13 pm »
Hi there,I think I can help you about the bed roughness,bed roughness is the one of the input that we used to calibrate the lit prof from lit pack so You have to used a few value of bed roughness to check it which is the best value to used it which means verify with your area study.please try it first and inform me .I have been used lit prof for my master and will used it for my PhD  this year 2014.You can send message to me at mdrodila@umt.edu.my.


regarads

MDRODILA
UMT
PENISULAR MALAYSIA
MALAYSIA