Author Topic: How can i fix this error  (Read 346 times)

AliH

  • Guest
How can i fix this error
« on: November 06, 2017, 09:52:06 pm »
Hello Everybody,

I have created both curvilinear grid and bathymetry files in MIKE21C. I ran the model but i got an error. To fix the problem, when i change the initial condition, sometimes it says "high water level" or "low water level" and it does not get stable. The middle of the channel is the deepest point. When i check the output file, the water depths after and before the deepest point are logical but the model gets unstable at that point.

I also increased the number of elements and created a new grid and then a new bathymetry file, but i got the same error. I also changed other parameters such as, boundary conditions, Manning coefficient, but it did not work either.

Could you please guide me how to fix the problem?
Regard
« Last Edit: November 06, 2017, 10:04:05 pm by AliH »