Author Topic: Help with LITPROF  (Read 634 times)


  • Posts: 1
    • View Profile
Help with LITPROF
« on: January 14, 2018, 06:21:12 am »
Dear MIKE users,

I would be grateful if someone could provide some advice in my question about LITPROF.
I am trying to simulate the erosion caused by 2 different conditions:
a. H=2m and T=7s
b. H=2.5m and T=8.3s
However, the results are quite similar, which is not realistic, I think.
The profile slope is 1in3. The d50 is 1.1mm (for case 1) and 18.1mm (for case 2).
I had a similar problem in the past: all settings same, only difference the d50, however the results similar.
I believe the problem is in defining the PRFTABL dimensions?
I have attached the dimensions of the PRFTABL that I am using.
Any answer would be much appreciated.

Kind regards,
« Last Edit: January 16, 2018, 05:10:40 am by akal »