Author Topic: MIKE HYDRO NAM Autocalibration  (Read 518 times)

Saleem

  • Posts: 7
    • View Profile
MIKE HYDRO NAM Autocalibration
« on: May 22, 2018, 08:22:41 am »
Hi all,

I am trying to calibrate MIKE HYDRO NAM for a single catchment under Rainfall Runoff module only. I set everything to calibrate the model but calibration tool is not working at all. In short, it only shows observed Q but produce no simulated Q. Not a single parameter is updated.  What could be the possible reason for this.

Thanks in advance and any assistance is appreciated.

Regards

Saleem

  • Posts: 7
    • View Profile
Re: MIKE HYDRO NAM Autocalibration
« Reply #1 on: May 26, 2018, 09:16:17 am »
When the same model is run in MIKE 11 using MIKE Classic engine, the model is calibrated quite well. However, again it did not run with MIKE 1D engine in MIKE 11. This is quite weird and challenging.

Can anybody explain what could be the possible reason?
Regards