Author Topic: Standard boundaries  (Read 90 times)

Medria_85

  • Posts: 1
    • View Profile
Standard boundaries
« on: October 07, 2018, 07:14:49 pm »
Hi everyone,

I would like to know how I can properly set up the parameters of standard boundaries in MIKE Hydro. The source of water from all upstream chainage in the model is from rainfall. However, when I run the simulation, there is always an error message: "0 is defined as an open boundary in the model, however no open boundary is defined (EN_ERR_OpenBndMissing).

I have defined the parameters as follow:
Type: Rainfall
Location type: Distributed source
Input type: Time varying (with rainfall data- dfs0 file)

I wonder if there is another parameter that I have missed? I would like to know how to solve the problem.

Thank you very much
Cheers

Medria



EliasMoussoulis

  • Posts: 4
    • View Profile
Re: Standard boundaries
« Reply #1 on: January 09, 2019, 08:12:22 am »
Hi Medria,
This may come a bit late but it may also be relevant to other users. The error says there is no open boundary defined for the upstream end. A discharge (or water level) inflow boundary condition is required for the upstream end while a Q-H or water level boundary condition is required for the downstream end. The distributed source boundaries are considered as lateral inflow (or outflow) boundaries and so is rainfall. Normally rainfall is fed in a Rainfall Runoff model like NAM (is that what you wanted to do?) and subsequently linked with or fed into the 1D river model.
Hope this helps.
Elias