Author Topic: FEFLOW with pichem  (Read 442 times)


  • Posts: 1
    • View Profile
FEFLOW with pichem
« on: October 29, 2019, 02:49:54 pm »
Dear all,

I am a new user in FEFLOW. So please excuse me if this is a very simple question. I want to apply a mass transport together with piCHEM for my model, particular an acid mine drainage (amd) problem. I am starting with a 2D model with a horizontal projection; include transport of mass and selecting a transient flow and mass. I have attached a picture of the polygon.

I have assigned hydraulic head under Boundary Conditions (Fluid flow) on the bottom and top by selecting nodes along the border. I have also assigned conductivity levels (K_xx, K_yy, K_zz) and the dispersivities.

I have a chemical composition of the input solution that is being injected from the bottom which can be used in the PHREEQC input files. I set up this solution as boundary conditions by assigning a Mass Concentration-BC e.g. 100mg/L/. I tried to run the simulation but nothing happened.

I would appreciate your help on that.

Thank you very much in advance.

Kind regards,

Peter Schätzl

  • Posts: 1014
    • View Profile
    • Aquasoil
Re: FEFLOW with pichem
« Reply #1 on: November 25, 2019, 12:30:31 pm »
I'd recomment to contact the support about this - I don't think there are too many forum users with piChem experience.
Aquasoil Ingenieure und Geologen GmbH
Berlin - Germany