Author Topic: Mesh Refine Points  (Read 303 times)


  • Posts: 2
    • View Profile
Mesh Refine Points
« on: April 20, 2020, 03:43:49 am »
It would be helpful to have a selection tool that only selected points are refined during mesh generation. 
ie. only refine bore locations, and leave piezometer locations unrefined.

Carlos Rivera

  • Administrator
  • Posts: 87
    • View Profile
Re: Mesh Refine Points
« Reply #1 on: June 25, 2020, 09:32:32 am »
Hi Mark,
Nowadays you can achieve the task you are looking through FEFLOW 7.3. You can select a minimum volume (element selection), which contains the points/boreholes data. The Meshing panel with TetGen will create a new local mesh in this selected volume. Also as result, the Selection panel will contain the node selection of the borehole points.
Dr. Carlos A. Rivera Villarreyes
Director Sales Service & Support

Peter Schätzl

  • Posts: 1019
    • View Profile
    • Aquasoil
Re: Mesh Refine Points
« Reply #2 on: June 25, 2020, 10:22:41 am »
I think Mark is referring to the Triangle refinement option. While for polygon edges, only selected ones may be refined, for line and point add-ins the refinement is always done for all of them.
Aquasoil Ingenieure und Geologen GmbH
Berlin - Germany