Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - amengel

Pages: [1]
1
MIKE SHE / Error with Irrigation sourced from River
« on: April 16, 2020, 02:35:51 pm »
Hello,

I am seeing the following error:

"Irrigation
  Error: Specified chainage (18870) exceeds limits of
  Branch: Bee Branch
             Min, max chainage : 148, 6794."

However, the branch down stream chainage is over 20000. Why is MIKE SHE/MIKE11 not allowing withdrawals from the specified chainage? Is it a problem with MIKE SHE or MIKE11?

Thank you,
Angelica

2
MIKE 11 / Error no. 9: Structure not specified in model setup
« on: December 17, 2018, 07:46:49 pm »
Hello,

I am working on adding in structures to a MIKE11 network that was previously running well. After I add the structures in the river network and try to run it, I get this error for all of the added structures, "Error no. 9: structure in Branch x at chain y is not specified in the model setup." Does anyone know which model setup? I have added them in to the MIKE11 network but I'm not sure where else I need to define them.

Thank you,
Angelica

3
MIKE SHE / Irrigation Application for Subsurface Irrigation
« on: April 25, 2018, 04:47:13 pm »
Hello,

I am developing a model for an area that has large areas of sugarcane which is irrigated through subsurface methods (seepage irrigation). In seepage irrigation, water is pumped into small, lateral ditches within the fields and the water table is raised so that capilary forces draw water into the root zone. Other than building the ditches in MIKE11 and pumping water in to raise the water table, do you have any suggestions of how I can use the irrigation application methods already available in MIKESHE? I was thinking of the sheet application but this isn't quite right and I would lose a lot more water to ET than in seepage irrigation. I was also thinking that I could use drip applied and try to match application rates to seepage rates, but the issue here is that drip is much more efficient than seepage and I won't lose enough water to ET.

Thank you

4
MIKE SHE / Error with irrigation command areas
« on: November 30, 2016, 03:50:26 pm »
Hello,

I am getting the following error when pre-processing my model, "Error: the remote well at (x,y) is pumping from the same layer(s) as the shallow well for command area x."

I have no wells at the specific coordinates given in the error message. I have one close by, but not in that exact location. Any ideas why I am getting this message? Any ideas how I can fix it?

Thank you,
Angelica

5
MIKE SHE / No entry for requested module found
« on: November 17, 2016, 05:27:23 pm »
Hello,

I am trying to complete the Sound tutorial and as I am saving the boundary condition profile series files, I get this message "No entry for requested module found!" Any tips?

Thank you,
Angelica

6
MIKE SHE / Error: Invalid origin of input file
« on: September 26, 2016, 10:37:30 pm »
I inherited an old MIKESHE model and I am working on updating it. I had to change the model domain and now when I try to complete the pre-processing I get this error, "Invalid origin of input file (origin of land use file). Must be located an integer no. of simulation grid cells from the simulation grid origin (origin of domain file)."

I can't seem to find any help anywhere. I have done work re-creating the landuse file, but I am having no luck. Any ideas what may be my problem?

Thanks,
Angelica

Pages: [1]